09-23-2015, 03:47 AM
Hey, wondering if you have advice for the gasket process when joining the cases once it gets here (Threebond 1211 is on order). Might have missed a post. Has really good reviews, along with your recommendation here, which pointed me to it.
Some instructions for RTV etc say finger tighten, let dry an hour, then torque. Other kinds say torque away. No re-torque necessary. Not sure about this 1211 stuff directions wise (not here yet).
Got new rear main seal this morning to put in, and clutch should be here in hours. Got needed circlip, all go for re-assemble. Only 2 more bearings to press, only seals after that.
Oh, guess I get the fun of taking off the flywheel first. (joy)
r
Some instructions for RTV etc say finger tighten, let dry an hour, then torque. Other kinds say torque away. No re-torque necessary. Not sure about this 1211 stuff directions wise (not here yet).
Got new rear main seal this morning to put in, and clutch should be here in hours. Got needed circlip, all go for re-assemble. Only 2 more bearings to press, only seals after that.
Oh, guess I get the fun of taking off the flywheel first. (joy)
r