One of the 1st

[jdbass]

ouch calif smog on such an old car.... hard.
you have to do the im240 rolling load test at 2 speeds. 15 and 25mph.

the fuse box has the jump fuse called diag. remove it.
or see here for the 4 pin plug if fitted. http://www.fixkick.com/CEL/DLC/DiagJump.html

yes, they would have a fit with that flashing, most will go, omg what is that?

GOOD luck passing for SURE!

get the pre inspection so CaL , epa cant see you fail. (if the exhuast smells rich it will)
here is a 95 passing it has tighter pass fail limits. (but was a close shave on HC) my guess is his cat was near dead. but not dead.
http://www.fixkick.com/smog/smog95-16v-passing.jpg

... jim

---

ouch calif smog on such an old car.... hard.
you have to do the im240 rolling load test at 2 speeds. 15 and 25mph.

the fuse box has the jump fuse called diag. remove it.
or see here for the 4 pin plug if fitted. http://www.fixkick.com/CEL/DLC/DiagJump.html

yes, they would have a fit with that flashing, most will go, omg what is that?

GOOD luck passing for SURE!

get the pre inspection so CaL , epa cant see you fail. (if the exhuast smells rich it will)
here is a 95 passing it has tighter pass fail limits. (but was a close shave on HC) my guess is his cat was near dead. but not dead.
http://www.fixkick.com/smog/smog95-16v-passing.jpg

yeah... no Diag fuse far as i can tell and I seem to have a 3-pin DLC connector... but as I say... already flashes code 12... I just have to re-set the light so it doesn't flash codes.
... jim