06-27-2015, 12:26 PM
Hi Fixkick,
On your TPS calibration page, the FSM step 3 says to rotate the TPS until ohms change from 0 to infinity, but on this thread you said to rotate TPS until ohms drop below 300, which is it? Or is this basically saying the same thing because it never gets to 0?
Thank you!
On your TPS calibration page, the FSM step 3 says to rotate the TPS until ohms change from 0 to infinity, but on this thread you said to rotate TPS until ohms drop below 300, which is it? Or is this basically saying the same thing because it never gets to 0?
Thank you!