06-24-2013, 01:40 PM
Put new plastics in today with high hopes. Still not able to shift in to 1st or 2nd. Other gears go in freely and feel normal. Trans was shifting normally prior to swap out and new clutch. Looking at the top of the case there is a 22mm bolt on each side of the case. Pulledc the left one and had 2 springs, an inner and an outer. Not able to break the R side loose as it is tight from underneath. It feels like there is a restriction in the lateral movement needed to move the ball socket to the right which is the direction it moves when going to 1st or second. Looked at the schematics on the trans page here and am confused. It shows a single spring on the left and a double/inner & outer on the right. I definitely have a double on the L and not sure on the right until I can get the bolt cap off. Any ideas whats going on ? It just feels to me like something is either hitting or not releasing far enough in the ball socket area. Thanks for any help.