04-18-2015, 07:36 PM
Hey Kickfix.
The ECU part number is 33920-71EED. I've found a manual with wiring diagram for the stepper EGR engine: http://www.rhinoman.org/manuals/vitara/99501_61A20.pdf so hopefully this will give me what I need.
I don't know the market code for the donor car that the engine came from. The car is crushed now. I know it was a 1996 LWB auto JLX SE. I could ask Suzuki to help, I have the donor car VIN number.
Ignore my comment on CDI. It was a slip of my tongue. I meant to say ECU, I get the two mixed up. Ignore. I am using the original ECU.
Coax cable no problem. I don't really want to use the factory harness, it has extra wires, wrong length. If the project becomes too difficult then I can try a factory harness. I have a harness and matching ECU from a 1997 stepper EGR Vitara which might work. I will check later if the ECU is the same as the one that came with my new engine.
The ECU part number is 33920-71EED. I've found a manual with wiring diagram for the stepper EGR engine: http://www.rhinoman.org/manuals/vitara/99501_61A20.pdf so hopefully this will give me what I need.
I don't know the market code for the donor car that the engine came from. The car is crushed now. I know it was a 1996 LWB auto JLX SE. I could ask Suzuki to help, I have the donor car VIN number.
Ignore my comment on CDI. It was a slip of my tongue. I meant to say ECU, I get the two mixed up. Ignore. I am using the original ECU.
Coax cable no problem. I don't really want to use the factory harness, it has extra wires, wrong length. If the project becomes too difficult then I can try a factory harness. I have a harness and matching ECU from a 1997 stepper EGR Vitara which might work. I will check later if the ECU is the same as the one that came with my new engine.