04-03-2015, 05:48 AM
I have received the Mastertech, hooked it up, igt shows exactly the same readings as Tech1 referred before. So the scanner is proved ok. I will check again but using a Suzuki mass storage cartridge - before, two different GM cartridges used.
Related to the ECT sensor reading, I want to sort out the 200 ohm offset issue by making up an alternative, custom sensor - a 2 kOhm thermistor fitted inside a pocket or even surface mounted somewhere on CW outlet area. This way I hope I can reduce the voltage seen by the ECM.
Any idea what is the ECT sensor pocket thread size ?
Related to the ECT sensor reading, I want to sort out the 200 ohm offset issue by making up an alternative, custom sensor - a 2 kOhm thermistor fitted inside a pocket or even surface mounted somewhere on CW outlet area. This way I hope I can reduce the voltage seen by the ECM.
Any idea what is the ECT sensor pocket thread size ?
95 Geo Tracker 2 doors hard top 3speed A/T 16V 1.6l Fed 4x4