Login Register

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
1990 ECU blown diode?
#10
The cap, rotor, wires and properly gapped plugs were put in about six months ago. I pulled the cap to check for moisture inside, and it was dry.
The fuel pump and fuel filter were changed about the same time.
When it didn't run last week it only flashed 12's. Nothing else.
The ground to the TPS looks kind of shoddy, like someone tried to fix it at one time. Seems short, like it is pulling the wire. It is grounded to the bolt for the thermostat. not sure if this is correct. Could I move it to a better body ground somewhere?

Neil
Reply


Messages In This Thread
1990 ECU blown diode? - by Neil - 01-15-2015, 11:16 AM
RE: 1990 ECU blown diode? - by fixkick - 01-15-2015, 12:19 PM
RE: 1990 ECU blown diode? - by Neil - 01-15-2015, 01:16 PM
RE: 1990 ECU blown diode? - by fixkick - 01-15-2015, 10:34 PM
RE: 1990 ECU blown diode? - by Neil - 01-16-2015, 09:25 AM
RE: 1990 ECU blown diode? - by fixkick - 01-16-2015, 10:58 AM
RE: 1990 ECU blown diode? - by fixkick - 01-16-2015, 10:54 PM
RE: 1990 ECU blown diode? - by Neil - 01-26-2015, 01:12 PM
RE: 1990 ECU blown diode? - by fixkick - 01-26-2015, 11:09 PM
RE: 1990 ECU blown diode? - by Neil - 01-27-2015, 12:33 AM
RE: 1990 ECU blown diode? - by fixkick - 01-27-2015, 03:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)