12-20-2014, 05:39 AM
(This post was last modified: 12-20-2014, 05:39 AM by barnbiketom.)
W E L L...still 12-1500 
Tore into it and found:
Factory TV screw is GOOD un touched ,, still white paint.. TV is closed and dashpot working..??
air bleed screw WAS ALL THE WAY IN.... previous owner had hi idle problem.???
left it still in all the way. keep reading>>>
gaskets all GOOD. injector O-rings all GOOD?? replaced em anyway. haven't tried hot soak yet..
I found the IAC CLOSED when I tore it apart. it was still hot>>>>
I blew thru it.. it was sealed. but I also screwed in the adjustment one turn just in case...
also water lines clear..
ISC..seems to be working BUT when you unplug it.. idle settles to 1000.. plugged in, it goes to 12-1500
I replaced a couple suspect hoses, and propane checked it, sprayed carb cleaner all over and under .. etc.. can't find any vacuum leaks..
??? ???@$@#%??
no check engine light either, bulb tests ok.. it lights up engine off key on...
Tore into it and found:
Factory TV screw is GOOD un touched ,, still white paint.. TV is closed and dashpot working..??
air bleed screw WAS ALL THE WAY IN.... previous owner had hi idle problem.???
left it still in all the way. keep reading>>>
gaskets all GOOD. injector O-rings all GOOD?? replaced em anyway. haven't tried hot soak yet..
I found the IAC CLOSED when I tore it apart. it was still hot>>>>
I blew thru it.. it was sealed. but I also screwed in the adjustment one turn just in case...
also water lines clear..
ISC..seems to be working BUT when you unplug it.. idle settles to 1000.. plugged in, it goes to 12-1500
I replaced a couple suspect hoses, and propane checked it, sprayed carb cleaner all over and under .. etc.. can't find any vacuum leaks..
??? ???@$@#%??
no check engine light either, bulb tests ok.. it lights up engine off key on...