i think your car uses the 0.016" setting, like the 91 to95's year here, my page is usa cars made in CAMI canada.
do you have a photo of your throttle body.?
set the gap to 0.016"
with the dash pot retracted. set it, so the switch just drops below 300 ohms.
the other 2 gauges are for validation. checks. only
my matrix table shows them all.
http://www.fixkick.com/sensors/tests/TPS...tml#matrix
my wild guess is after the USA ended TBI cars in 1995, i see other countries used them up to year 2001 about.
but ive never seen any Santana.
wiki
Santana broke its relations with Suzuki in 2009
http://www.fixkick.com/sensors/tests/TPS...tml#matrix
do you have a photo of your throttle body.?
set the gap to 0.016"
with the dash pot retracted. set it, so the switch just drops below 300 ohms.
the other 2 gauges are for validation. checks. only
my matrix table shows them all.
http://www.fixkick.com/sensors/tests/TPS...tml#matrix
my wild guess is after the USA ended TBI cars in 1995, i see other countries used them up to year 2001 about.
but ive never seen any Santana.
wiki
Santana broke its relations with Suzuki in 2009
http://www.fixkick.com/sensors/tests/TPS...tml#matrix
http://www.fixkick.com