I am back, and we finally got it running. We had to remove the set bolt that holds the dizzy in place and move the dizzy counter clockwise about 2" to get it to run. The #1 wire is set at the 11 o'clock position. I replaced the timing belt and did not move anything but screwed up by not checking all timing marks. It runs good on the road. Can I just pull the dizzy out and rotate the shaft until I can re-install the set bolt on the dizzy housing and set the timing?
Puzzler
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
RE: Puzzler - by fixkick - 08-09-2014, 01:15 AM
RE: Puzzler - by mbplath - 08-18-2014, 04:16 AM
RE: Puzzler - by fixkick - 08-18-2014, 09:20 AM
|
Users browsing this thread: 1 Guest(s)