175 with any IR pyro gun is 180F. so the stat works. your good,. but what about the ICA tube temps., many times its just a hose blocked.
those 3 screws are a problem.
id find a new TB. (used)
the acutal IAC does not come out. all you can do is see it messup
if trying to get buy, then block the holes, sure RTV.
i find using lots of heat to a screws will get them out. takes care not go get the Alum too hot.
i heat the head real fast for short time then attack them.
![[Image: cold-air2w.jpg]](http://www.fixkick.com/fresh-air/Slide_Show/images/cold-air2w.jpg)
your IAC IR readings show it blocked, this path
at the hose side or the base gasket under TB is wrong, backward, home made wrong, or blocked.
what if H2O is blocked HERE
http://www.fixkick.com/fresh-air/Slide_S...ge_13.html
is it a bad IAC or is the water flow blocked.
88F is wrong. (but depend on time running and distance) if 20 miles ran, that is DEAD wrong 88f
you very close to true cause.
i think the book says it closes at 158f
but every one i measured is 150F. so they do so a tad early, no big surprise.
those 3 screws are a problem.
id find a new TB. (used)
the acutal IAC does not come out. all you can do is see it messup
if trying to get buy, then block the holes, sure RTV.
i find using lots of heat to a screws will get them out. takes care not go get the Alum too hot.
i heat the head real fast for short time then attack them.
your IAC IR readings show it blocked, this path
at the hose side or the base gasket under TB is wrong, backward, home made wrong, or blocked.
what if H2O is blocked HERE
http://www.fixkick.com/fresh-air/Slide_S...ge_13.html
is it a bad IAC or is the water flow blocked.
88F is wrong. (but depend on time running and distance) if 20 miles ran, that is DEAD wrong 88f
you very close to true cause.
i think the book says it closes at 158f
but every one i measured is 150F. so they do so a tad early, no big surprise.
http://www.fixkick.com