07-10-2014, 11:21 AM
Next problem. Finally found another complete tranny/xfer case. Got it home and cleaned it up. Getting ready to install it and realized that it has a different output shaft spline count. Not sure what year the tranny I had was, somewhere around '91. I do know that the tranny I just purchased is a '96. Seems if it had been one year older, everything would fit perfectly. This is a huge problem because my rear drive shaft is custom made with CV joint (very expensive) and slip-yoke eliminator. I'm not even sure they make a slip-yoke eliminator for the '96 and up spline. Can't seem to find one. Not sure why they would only make one for the earlier spline???