'91 Sammy runs rough

[Jim Blackwood]

Thanks but I'm still a little confused. Should I put the resistor between pin A16, EGT temp signal and the return A24? That would cause current to flow as if the temp sensor was there, right?

My '91 Samurai never had the EGRT, the new engine did and I'm just guessing this ECM expects to see it. It is marked as 10-8-95 FE Sidekick. But if wiring it this way gets rid of code 51 I'm good. I guess I can try that and see if it works. Does the code have to be cleared? How?

Thanks,
Jim