Koyo Rear Wheel Bearings

[fixkick]

in 1996 step 7 changed.
there is no TSB covering this change it is a factory change (ghosted)

and nobody asks why the step 7 has GM grease slapped over, Shell koyo grease. (only GM book states that)

Nice! That’s more descriptive than the 1990 GM FSM. Also, I like how they added grease sloppiness to the retainer/bearing in the technical drawing.  

The one thing that bothers me about my retainer ring(s) is that both rubberized FIP gaskets were basically destroyed during removal. So much so that I removed them completely. I’m hoping the RTV does its job but I’ve never had 100% success with RTV. Eventually it leaks or on this case doesn’t seal.

Also, in the 1990 FSM, they call for GM# 1052366 sealant which I believe has been replaced by Threebond 1217h according to the internet. Is the Suzuki bond 1215 a rebranded Threebond product as well?

also the engine oil pan in the SUZ factory is RTV glued on, and then cured and then pressure tested. (no pan gasket used)OEM

the Threebond,  I used on my transmission M/T casings per the FSM. this works great. ( yes is the real maker of Suzuki sealant)
the axles were made in Iwata japan,  i'd bet there is no GM sealants used there in Japan. sure Threebond.
GM's books are very heavily modified, even with errors.

here is my list of errors



http://fixkick.com/IGN_timing/error-galore.html


in some GM FSM books this sealant topic is only covered in the brake pages. 

good luck with yours. some parts are now hard to find.