Got time for another clutch question?
After a extensive test of my patience and back I have everything back together. Stop and switch(s) adjusted, cable back on the hook. Final adjustment would be at the bell housing. The threaded part of the cable [kind with the rubber, not two lock nuts] is too short as it is. I run out of slack at the clutch lever about 1/2 way through the radius-ed end nut . I found the little mark on the clutch shaft end and it is lined up with the one on the arm. Square hole in the clutch pedal arm is in same location, the weld on the clutch shaft was starting to crack but had not gone through.
Any suggestions?
After a extensive test of my patience and back I have everything back together. Stop and switch(s) adjusted, cable back on the hook. Final adjustment would be at the bell housing. The threaded part of the cable [kind with the rubber, not two lock nuts] is too short as it is. I run out of slack at the clutch lever about 1/2 way through the radius-ed end nut . I found the little mark on the clutch shaft end and it is lined up with the one on the arm. Square hole in the clutch pedal arm is in same location, the weld on the clutch shaft was starting to crack but had not gone through.
Any suggestions?