04-13-2021, 02:46 AM
what is precision stock is bearing outer bearing shell bores and rod end outer bore sizes (bearings not present) and is checked to , for sure if a bearing was ever spun.
a shop checks all that. never guess. (inside mic)
and cam bores , align bored. (ours have no fitted bearings)
if not true this, omg the bearing crush factors are FAIL. fail hard.
some things must be near prefect, and this is it. (and is spec'd in the manual this, and very little error allowed)
the bearing inside diameter is based on crush factor that never changes. ever.
that is why I do both ways on bearings, mic'd (micrometer) both, then at full torque plastic gauge'd if fails I know for sure I messed up. I take all mic readings and do the math to compute bearing clearances, then later plastigauge tells me I AM NOT WRONG.
to be sure I trust nothing and prove all, that is possible.
a shop checks all that. never guess. (inside mic)
and cam bores , align bored. (ours have no fitted bearings)
if not true this, omg the bearing crush factors are FAIL. fail hard.
some things must be near prefect, and this is it. (and is spec'd in the manual this, and very little error allowed)
the bearing inside diameter is based on crush factor that never changes. ever.
that is why I do both ways on bearings, mic'd (micrometer) both, then at full torque plastic gauge'd if fails I know for sure I messed up. I take all mic readings and do the math to compute bearing clearances, then later plastigauge tells me I AM NOT WRONG.
to be sure I trust nothing and prove all, that is possible.
http://www.fixkick.com