04-10-2014, 10:13 PM
the first step is to pull the wire off the oil sender (oops its already fell off?) and ground the wire, (yell-blk)
if the lamp glows now, the lamp and path, is good, if not?, the sender is bad, or the oil pressure is below 5psi.
the lamp tests are in the FSM. and is linked in books. the 96 online book has same set up.
the key to this is here.
off the schematics page.
see this
http://www.fixkick.com/power-elect/95%20...5GAGES.pdf
see page 2, 16v
see the oil light, is just 2 wires. one is power, and power is shared in the head, so if one has power they all do.
good luck, with your lamp. i think the wire fell off or the sender gave up the ghost.
if the lamp glows now, the lamp and path, is good, if not?, the sender is bad, or the oil pressure is below 5psi.
the lamp tests are in the FSM. and is linked in books. the 96 online book has same set up.
the key to this is here.
off the schematics page.
see this
http://www.fixkick.com/power-elect/95%20...5GAGES.pdf
see page 2, 16v
see the oil light, is just 2 wires. one is power, and power is shared in the head, so if one has power they all do.
good luck, with your lamp. i think the wire fell off or the sender gave up the ghost.
http://www.fixkick.com