1990 tracker -no start FI fuse?

[rjm]

alarms
i take each wire follow it to its source and put it back to factory stock at each place.
one good reason not to have an alarm. (after market)
is if needing shop work on a car,  they then will not do the job or charge 2 times for figuring out which of 100 alarms it is, if even possible this old.
that alarm can be 29 years old, put on a 30 year old car and no documents on it exist now....

non OEM.

Ok - pulled all the alarm wires and cleaned up under dash - actually was a real clean install but now we are back to stock. 1 less concern in future. Still no start! Fires up immediately with starting fluid. Will run on propane torch set up. I pulled the ecu and pics attached for your review.


looking to replace those caps:
I suspect the 3 capacitors to be replaced are:

50v  100uf
50v 10uf
50v 47uf OR IS IT 4.7uf ?
I found these at digikey  - all Nichicon brand
UBT1H10MPD1TD (100uf)
UVP1H1DOMED1TD (10uf)
The 4.7 or 47 will also be the UVP series
[size=3][size=3][size=7]Do you consider these acceptable for the application?[/size][/size][/size]