08-17-2020, 10:05 PM
Ok thanks for the in depth reply.
Yes TPS 5v good. Ground is good. 0Vdc at idle good. (Even installed a different TPS just to dbl check)
I have an actual NOID light testing set. Not LED. I assume those lights work ok for this?
Just want to clarify my next steps:
-I should remove the injector from horn and have it plugged in to the harness to do NOID NPN/PNP test? What does removing it do?
"this is true 1991 up, never on sammi." Are you saying on my 92 Samurai I can't do this test?
"as you can see R225 must not be burned open." I can't find this resistor on the board, do you have a pic showing where it is? Or I can post a pic of mine and you could point it out.
Thanks for helping me figure this out!
Yes TPS 5v good. Ground is good. 0Vdc at idle good. (Even installed a different TPS just to dbl check)
I have an actual NOID light testing set. Not LED. I assume those lights work ok for this?
Just want to clarify my next steps:
-I should remove the injector from horn and have it plugged in to the harness to do NOID NPN/PNP test? What does removing it do?
"this is true 1991 up, never on sammi." Are you saying on my 92 Samurai I can't do this test?
"as you can see R225 must not be burned open." I can't find this resistor on the board, do you have a pic showing where it is? Or I can post a pic of mine and you could point it out.
Thanks for helping me figure this out!