New Owner

[fixkick]

Update: Lots of progress then a setback.

Timing belt with new bottom cog and bolts (top and bottom) - done.
Water pump - done.
Valve lash - done.

Then a setback.
Installed new o-rings on distributor. Began to install distributor, rotor turned when engaging gears (as expected). Went smoothly until starting to engage o-ring (oil on new o-ring, no nicks or gouges on shaft or housing). Very difficult to seat dizzy the final half-inch or so (caught on o-ring). Applied more pressure, after making sure dizzy was going in straight, then “snap”! Broke the dizzy housing where the shaft meets the body, just above the o-ring.
So now I need a new housing (at least).
Is it best to try to find a new housing or just get a new distributor? If so, which brand to avoid?
Engine is VIN 6, 16 valve. 1995 Tracker. Dizzy is 3-prong electrical plug and .475” diameter rotor cam.

Thanks in advance.

sorry for you that.
yes 92 to 95 fits in USA. 16v all are same those year but not 8v.