Mr fixkick, thank you for answering so thoroughly, I did leave out a lot of info, sorry about that.
This Tracker has the 8v. The sticker under the hood does not say California.
The DLC connector has 4 pins. I incorrectly referred to the pins with numbers 2 + 3 when I meant B + C.
I found the NAG switch. I took apart the gauge cluster and removed the NAG switch connector (which had pink and green wires). I tried to read the codes again with the NAG switch removed but still do not see any flashing in any state -- ignition on, cranking, or engine running. I am using a piece of wire. The light is still on, so I assume then we know it's a real code and not a NAG light coming on. What am I missing sir?
Also, there are a few wires going nowhere next to the DLC connector... What is the single wire (orange) pictured far right in the photo I attached? I found The temp gauge sender located under the thermostat was broken off. I replaced it and wired it up but I can't figure out where the heck it is supposed to go.
This Tracker has the 8v. The sticker under the hood does not say California.
The DLC connector has 4 pins. I incorrectly referred to the pins with numbers 2 + 3 when I meant B + C.
I found the NAG switch. I took apart the gauge cluster and removed the NAG switch connector (which had pink and green wires). I tried to read the codes again with the NAG switch removed but still do not see any flashing in any state -- ignition on, cranking, or engine running. I am using a piece of wire. The light is still on, so I assume then we know it's a real code and not a NAG light coming on. What am I missing sir?
Also, there are a few wires going nowhere next to the DLC connector... What is the single wire (orange) pictured far right in the photo I attached? I found The temp gauge sender located under the thermostat was broken off. I replaced it and wired it up but I can't figure out where the heck it is supposed to go.