12-15-2019, 10:44 PM
(12-15-2019, 12:35 PM)Jules Wrote: I sprayed a little starter fluid in this morning and it smoked a bit. Then I put a little more and it started then died! Looks like it's working good so far. Next step is attaching the stock Esteem gas tank and firing her up for a real test.
I'm getting excited! Will post a video if/when I get it running. Thanks for all the help.
P.s. I also got a compression tester and tested one cylinder - it was about 180, so I didn't bother testing the others yet.
looks like spark is ok..
so fueling is next.
the fuel pump must run and reach correct pressure levels are next. The FPR on the fuel rail regulates this pressure level, the pump can do 60psi and is too much , thus the FPR device.
your close very close.
180 is good on cold engine. better warm and better holding throttle open (some) doing the test.
keep warm ! happy holidays.
http://www.fixkick.com