I changed out the clutch cable and #7 bushing a few months back, so I'm really looking for the best way to install clutch shaft #5 during the time I replace the clutch. I'll be following the clutch replacement instructions outlined on your website, so if theres a way for me to replace the shaft #5 during the same time, I'd like to do it.
The question is would I have to remove the bell housing from the transmission to do this, and when I replace the clutch shaft, how do I align the mark on the shaft vertically in relation to the housing, so when it comes time to put the arm on it would be seamless
The question is would I have to remove the bell housing from the transmission to do this, and when I replace the clutch shaft, how do I align the mark on the shaft vertically in relation to the housing, so when it comes time to put the arm on it would be seamless