09-09-2019, 09:05 AM
(09-09-2019, 04:22 AM)tmanstein Wrote: Maybe I should start a new thread for this, but now working on the clutch while waiting for parts.
I replaced the clutch cable which was extremely stiff. After replacing it did not make it better. Firewall is good, welds are good and spline looks good. When I was doing the inch test I noticed that I can not move lever #11 by hand and thought this could be my problem, but not sure if I am reading it correctly that I should be able to move easily. If it should be easy what is my problem?
bell lever 11 , end is 6 times the force of the pedal, so with 25lbs push in the pedal the end of 11 is 6 times that or 150 lbs.
also the clutch disk must lockup all 95 HP and torque of the engine. (and super higher torque in 1st gear)
that means the PP, pressure plate is super powerful force.
The cable gets cut groove inside it that happen only under tension then binds!. a new cable is always first. they really stink when bad, horrible. effects.
i forgot did you change that cable>?
http://www.fixkick.com