08-19-2019, 02:36 AM
my parts list shows no IRONs for 3sp box.
seen just below the right bell mount hole, so my guess not there and in the way.
my best guess, is
drop axle or lift engine some. front mounts removed,
the other trick , gee, is hard, remove all shifter inside car and console center,
and drop tail cross member or trans, just enough to get the front of the engine higher, but ID bet for sure the front prop shaft needs to be pulled, and box xfr case drain for sure.
or you will get a flood if it drops by self that prop shaft ,
the trick here is float the whole engine/trans/xfer case) and then while floating on jacks and wood blocks raise the front of engine to max possible and not break things.
then pan may be , pulled, but ive never tried this, but have on jeeps, and failed, (still leaked after failed)
seen just below the right bell mount hole, so my guess not there and in the way.
my best guess, is
drop axle or lift engine some. front mounts removed,
the other trick , gee, is hard, remove all shifter inside car and console center,
and drop tail cross member or trans, just enough to get the front of the engine higher, but ID bet for sure the front prop shaft needs to be pulled, and box xfr case drain for sure.
or you will get a flood if it drops by self that prop shaft ,
the trick here is float the whole engine/trans/xfer case) and then while floating on jacks and wood blocks raise the front of engine to max possible and not break things.
then pan may be , pulled, but ive never tried this, but have on jeeps, and failed, (still leaked after failed)
http://www.fixkick.com