07-29-2019, 09:03 AM
yes, the worm gear clamps can work great.
just needs spin-tight tool to do that easy. hex driver.
the stock clamps there are not easy to remove at all. (down below)
the advantage of the factory clamps are easy install , in a factory,
and later if the hose shrinks (most good hoses dont) but if did, the worm gear clamp fails, (may)
There is nothing really wrong with the screw clamps if set at the right angle, and not so that Mr. rubber man only can reach it.
but both clamp types suffer for that problem. (just one spot there behind the pump, what angle there , you might think what is best for you.
good luck with your car !
just needs spin-tight tool to do that easy. hex driver.
the stock clamps there are not easy to remove at all. (down below)
the advantage of the factory clamps are easy install , in a factory,
and later if the hose shrinks (most good hoses dont) but if did, the worm gear clamp fails, (may)
There is nothing really wrong with the screw clamps if set at the right angle, and not so that Mr. rubber man only can reach it.
but both clamp types suffer for that problem. (just one spot there behind the pump, what angle there , you might think what is best for you.
good luck with your car !
http://www.fixkick.com