Dies when i give it gas

[bairan]

on that input of the ECU maf pin to ECU
do not exceed 4.75vdc,  ok?   most pins are protected but no need to take risks, and this pin is 1000 ohm ,exactly to ground it converts current to voltage for the ECU ADC>
also make sure the vref pin on the ecu is 4.75v to 5.25vdc,  I think you did but I forgot ,sorry if yes.

ok thanks, i will run some more cleaner thru it before i remove the injectors. So in limb mode the ECU does not use the injectors?