No injector pulse.... Is dead tachometer causing this?

[fixkick]

your eCU is dead, see test 1 again
hit control + F5 key together to see new page. after loaded.

http://www.fixkick.com/ECU/ECU.html#Tests


see rule 0 and 1 , in red here.

http://www.fixkick.com/ECU/ECU.html#Tests

---

if your 16v has a bad CEL lamp we can ignore it and use a meter.
seen
here.
see analog meter here, or LED test?

http://www.fixkick.com/CEL/DLC/DiagJump.html


CEL on all the time and code 12s fail? all codes fail, to flash?


that is NAG mode, remove the nag switch or slide it 1 time.
now CEL will Flash 12's (must) or some codes.
if CEL always dead (never glows), and fuses good, then use the meter test above. on volts range.
This convenient CEL pin allows easy CEL tests. when its burned out.


we will make it run, i promise.!!