02-27-2014, 02:55 PM
Ok,
So i measured the resistance between the Black wire (Pin 8) to ground & am getting 0 ohms.
Then i tested the resistance between the Ignition Coil & the Noise Suppressor (Brown/White cable) & i got 0 ohms.
I then tested the resistance between the brown wire (Pin 9) on the connector which goes into the Tacho on the Instrument panel, To the brown wire connected to the Noise Suppressor & am also getting 0 ohms...
And when i measure the voltage on the 12v wire (Pin 6) going into the tacho on the back of the Instrument panel to Ground i get 14v.
So it looks like there is no break in any of those wires.
But the Tacho still does not work.
So i measured the resistance between the Black wire (Pin 8) to ground & am getting 0 ohms.
Then i tested the resistance between the Ignition Coil & the Noise Suppressor (Brown/White cable) & i got 0 ohms.
I then tested the resistance between the brown wire (Pin 9) on the connector which goes into the Tacho on the Instrument panel, To the brown wire connected to the Noise Suppressor & am also getting 0 ohms...
And when i measure the voltage on the 12v wire (Pin 6) going into the tacho on the back of the Instrument panel to Ground i get 14v.
So it looks like there is no break in any of those wires.
But the Tacho still does not work.