03-26-2019, 11:30 PM
here is good gauge and not expensive to have in a shop as at least a backup to better gauges. ( a real shop gauge is rubber covered) but this is good one to use for sanity tests. ok?
https://www.ebay.com/sch/i.html?_from=R4...itleDesc=0
the correct adapter for USA pipe is
BSPT 1/8"-28TPI (threads-per-inch)
https://www.summitracing.com/search/part...pt-to-bspt
NPT on the outside, of the adapter and BSPT into the block male in to block , with no damage.
this is how it is done the correct way.
hope this helps.
there is no hot idle spec, on the G16 engine for Oil pressure, against all classes of oil sold in the market 2019
https://www.ebay.com/sch/i.html?_from=R4...itleDesc=0
the correct adapter for USA pipe is
BSPT 1/8"-28TPI (threads-per-inch)
https://www.summitracing.com/search/part...pt-to-bspt
NPT on the outside, of the adapter and BSPT into the block male in to block , with no damage.
this is how it is done the correct way.
hope this helps.
there is no hot idle spec, on the G16 engine for Oil pressure, against all classes of oil sold in the market 2019
http://www.fixkick.com