1996 Geo Tracker hesitation upon quick acceleration

[gorkyb]

bad dizzy wiring is real bad. misfire city. <-------
the engine is used in many cars, so there are lots of holes , not used.'
new head,
http://www.fixkick.com/engine/97-motor-p...ge_31.html

http://www.fixkick.com/engine/97-motor-p...ge_59.html

the rear cam cap is RTV at juncture, the 96FSm is on line and covers that. step. i even have this step expanced in my 97 show.
http://www.fixkick.com/engine/97-motor-p...ge_45.html <--- yes, I put the rtv under before I bolted down the cam cap, I went right off your page, great pictures btw. Where I got RTV is at the tip of the HV post under the distributor cap, I think I did this when I was trying to seal the distributor because I tought it was getting wet since the car would be hard to start every time after I washed it or in rainy days. Anyway, I cleaned that off already.

if not it leaks oil to back of head.


my guess is that hole is used on other intake mounts. other cars. X90? or Esteem/ or??? id not worry it.

Here are some pictures of my attempted wire repair. Taking the plug apart is not as hard as it seems just gotta take the time and have patience so one doesn't break the tiny clips holding each pin. I hope my soldiering was good enough to last for a while. Working on this old wiring in the cold weather doesn't help, it makes the already deteriorated wire insulation even more brittle and just by twisting a little bit by hand it breaks apart.