those are all bored in place, so must be re-ALIGNED bored on a machine shop.
in fact just like day one in the factory, over sized caps(smaller I.D.) it is bored to perfection.
know that the ID of bearing shells are based on that perfect boring, the shells are crushed and then fit. (very tricky this, and never ignored,)
just like cams are, (in a head or in a block)
i needed block and had took at like 5, and only one was good but crank a wreck)
G16s good enough for cores, is not easy to find. not now.
in fact just like day one in the factory, over sized caps(smaller I.D.) it is bored to perfection.
know that the ID of bearing shells are based on that perfect boring, the shells are crushed and then fit. (very tricky this, and never ignored,)
just like cams are, (in a head or in a block)
i needed block and had took at like 5, and only one was good but crank a wreck)
G16s good enough for cores, is not easy to find. not now.
http://www.fixkick.com