Misfire, but no DTC's?

[Fabricator]

In case you can't view the sensor data in the recently attached file...

Line 5: FUELSYS1 - Fuel System 1 (shows closed or open loop)
Line 6: FUELSYS2 - Fuel System 2 (does not exist on G16B?) {v6 or v8 , bank 2 system}
Line 7: LOAD_PCT - Engine Calculated Load Value (percentage)
Line 8: ECT - Engine Coolant Temp (celsius)
Line 9: SHRTFT1 - Short Term Fuel Trim 1 (percent)
Line 10: LONGFT1 - Long Term Fuel Trim 1 (percent)
Line 11: MAP - Manifold Absolute Pressure (kPa)
Line 12: RPM - RPM
Line 13: VSS - Vehicle Speed (kph)
Line 14: SPARKADV - Spark Advance (degrees)
Line 15: IAT - Intake Air Temp (celsius)
Line 16: MAF - Mass Air Flow (grams/sec)
Line 17: TP - Throttle Position (percent)
Line 18: 02SLOC (location of 02 sensors?)
Line 19: 02B1S1 - 02 Bank 1 Sensor 1 (volts)
Line 20: SHRTFTB1S1 - Short Term Fuel Trim Bank 1 Sensor 1 (percent)
Line 21: 02B1S2 - 02 Bank 1 Sensor 2 (volts)
Line 22: SHRTFTB1S2 - Short Term Fuel trim Bank 1 Sensor 2 (percent)
Line 23: OBDSUP (OBD requirements?)

Hope this helps!

Fabricator