10-01-2018, 07:24 AM
Home made slide puller. I created it to pull the silencer out of the aftermarket muffler on my hopped up Subaru WRX. Have used it for several things since.
It's a length of 3/8" NC ready rod with a some old pipe for the ram.
![[Image: 2192_30_09_18_4_14_43.jpeg]](http://www.fixkick.com/bbs2/Suzuki-bbs/gallery/2192_30_09_18_4_14_43.jpeg)
This is the latest mod to pull my pilot bearing. I just ground one end of the rod as shown and will hack off that end and keep it as a future bearing puller that can be attached again with a threaded hex rod connector.
![[Image: 2192_30_09_18_4_20_56.jpeg]](http://www.fixkick.com/bbs2/Suzuki-bbs/gallery/2192_30_09_18_4_20_56.jpeg)
Worked perfectly. Just have to be gentle and work your way around and around then POP! And the bearing slides down the shaft of the puller instead of onto dirt and grit or rolls into some spider infested corner of your shop.
It's a length of 3/8" NC ready rod with a some old pipe for the ram.
This is the latest mod to pull my pilot bearing. I just ground one end of the rod as shown and will hack off that end and keep it as a future bearing puller that can be attached again with a threaded hex rod connector.
Worked perfectly. Just have to be gentle and work your way around and around then POP! And the bearing slides down the shaft of the puller instead of onto dirt and grit or rolls into some spider infested corner of your shop.