06-06-2018, 09:43 AM
(06-01-2018, 09:32 PM)fixkick Wrote: one guy here found some very special hot rated epoxy that seal this, up(above photo). for exhaust system rated. (at least a stop gap measure or to test)
most 16v do this, if still stock is yours stock>?
all parts original on car?, , still have a CAT?
good luck to you !
I had the same issue with the exhaust manifold, I think it results from the back cylinder being served the EGR gasses which causes the cast pipe
to operate at a different temperature. I tried to get the Thorley style headers but they were out of stock. Luckily, I found a local guy who's
shop specialized in cast iron repairs. My cast header was heated in their oven and brazed while hot. So far, it is holding.